Filter
Top Products
32 Operating the Meter
Menu Commands
The following is a list of menu commands that are shown on the
fourth line of the display and selected by using the four function
keys (F1-F4).
AUTO Auto – returns the meter to the normal,
automatic temperature correction mode.
ABORT Abort clearing the memory
BEGIN Begin – confirms that the meter is ready to
perform time averaging to meet the requirements
of a specific standard.
CABLE Cable – changes the meter input from fiber optic
receiver to the standard cable input.
CANCEL Cancel making the selection and return to the
previous menu.
CONT Continuous – initiate logging for an undefined
interval.
CLEAR Clear the memory of logged data.
CLR Clear the screen and return to making real time
measurements.
DISCARD Discard this data point without storing it.
END End the logging run or averaging interval.
FO Fiber Optic – changes the meter input from the
standard cable input to the fiber optic receiver.
FREQ Frequency – change or enter a frequency.
GHz GHz – used to enter a frequency.
HR Hours – used to define a logging interval.
kHz kHz – used to enter a frequency.
LEFT Left – set menus for left-handed operation.
LOG Log the current measured value.