Filter
Top Products
97Chapter 16 Operation with a Fiber Optic Link
To set the meter to use the fiber optic receiver input...
1. Access the menu system by pressing the function key
that corresponds to the legend below MENU on the
bottom line of the display.
2. Press 8 (NEXT) to select the Second Menu Screen.
3. Press 3 to select CABLE/FO. A new screen will appear
that shows the current input status.
4. Press F1 (OK) to continue with the same input without
change. The meter will return to the First Menu Screen.
Press Esc to return to the measurements screen.
5. Press F4 (FO) to change to the fiber optic receiver
input. The meter will return to the First Menu Screen.
Press Esc to return to the measurements screen.
To set the meter to use the cable input...
6. Access the CABLE/FO menu as previously described.
A screen will appear that shows the current input status.
7. Press F1 (OK) to continue with the same input without
change. The meter will return to the First Menu Screen.
Press Esc to return to the measurements screen.
PROBE INPUT STATUS
CABLE ON:
FIBER OPTIC: OFF
OK FO
F1 F2 F3 F4
PROBE INPUT STATUS
CABLE OF:F
FIBER OPTIC: ON
OK CABLE
F1 F2 F3 F4