Filter
Top Products
Maintaining Your
X-Shop
Maintenance
F
or your own safety, turn switch “OFF” and
r
emove plug from power source outlet before
m
aintaining or lubricating your saw.
Do not allow sawdust to accumulate inside the saw. Frequently
b
low out any dust that may accumulate inside the saw cabinet and
the motor. Clean your cutting tools with a Gum and Pitch Remover.
The cord and the tool should be wiped with a dry clean cloth to
prevent deterioration from oil and grease.
C
ertain cleaning agents and solvents can
damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents which contain
ammonia. Avoiding use of these and other types of cleaning
agents will minimize the possibility of damage.
A coat of automobile-type wax applied to the table will help
to keep the surface clean and allow workpieces to slide
more freely.
If the power cord is worn or cut, or damaged in any way, have it
replaced immediately.
Make sure the teeth of the ANTIKICKBACK pawls are always
sharp. To sharpen:
1. Remove blade guard.
2. Rotate pawl toward rear of spreader so that teeth are above top
of spreader.
3. Hold spreader with left hand and place pawl over corner of
workbench.
4. Using a small round file (Smooth Cut) sharpen the teeth.
All repairs, electrical or mechanical, should
be attempted only by trained repairmen.
Contact the nearest Factory Service Center or Authorized
Service Station or other competent repair service. Use only
identical replacement parts, any other may create a hazard.
Lubrication
The gear case has been completely lubricated at the factory.
However, after six months to one year, depending upon use, it’s
wise to return your tool to the nearest Service Center for the
following:
•
Brushes replaced.
•
Parts cleaned and inspected.
• Relubricated with fresh lubricant.
• Electrical system tested.
• All repairs.
The following parts should be oiled occasionally with SAE No. 20
or No. 30 oil (Fig. 76).
1. Depth screw hinge.
2. Depth screw threads.
3. Tilt shaft pivot points.
104
.
WARNING
!
FIG. 76
3
1
2
WARNING
!
WARNING
!