Filter
Top Products
Attaching Sander Insert
The following Skil Sander Models may be used with the
sander insert: Models 7313 & 7500.
B
EFORE USING THE SANDER: Read the
i
nstruction manual that came with the
s
ander.
From among the loose parts, locate the following hardware (Fig. 25).
Item Description Quantity
S1 Sander Insert 1
S
2 Sander Bracket Right 2
S3 Sander Bracket Front 1
S4 Sander Bracket Left 2
S
5 Hex-head Screw (long) 2
S6 Wing Nut 10
S7 Washer 10
S8 Retaining Bracket 1
S9 Sander Fence 1
S10 Wear Bracket 2
S11 Hex-Head Screw (short) 8
Note: There are two sets of support brackets (
S2 & S4) depending
on which sander model is being used.
1. Make sure the sander switch is in the OFF position and the
cord is unplugged.
2. Install sanding belt per the sander’s original instruction manual.
3. Attach sander wear brackets
S10 to insert. (Fig. 25)
4. Fasten the right and left sander brackets
S2, S4 to the insert
using 4 hex-head-screws S11, 4 washers S7 and 4 wing nuts
S6 as shown. (Fig. 25)
5. Insert the sander, making sure that the tabs YY on the flat
brackets engage with the four slots XX on the sides of the
sander (Fig. 26).
6. Install the front bracket
S3 using 2 hex-head screws S11, 2
washers S7 and 2 wing nuts S6 as shown. Be sure the sander
is fimly installed and cannot work its way loose.
7. Attach retaining bracket
S8 onto bottom of insert using hex-
head screws S11, washers S7 and wing nuts S6 as shown.
8. Lift the red latch lever Y located at front of the wing opening.
The sander insert may be installed in the right or left wing.
9. Slip tabs X on edge of insert into rear of wing opening. (Fig. 27)
10.
Lower the front edge of insert
S1 into wing and lower the red
latch lever
Y
. (Fig. 28)
11. Install the fence
S9 using the two wing nuts shown. (Fig. 28)
12. Lock the sander switch to the ON position.
13. Make sure the main table saw power switch is in the OFF position.
14. Insert the router electrical plug into the accessory power outlet.
15. See the section on “Operation of the Accessory Power Outlet”.
16. Lower the saw blade below the table before operating the sander.
17. Operate the sander in accordance with the sections entitled
“Sander Safety” and “Operation of a Sander with the Sander
Insert” in this manual.
1
2
x5
XX
yy
Y
X
Y
S3
S
S9
S4
56.
1
2
x5
S11
S
8
S7
S6
S9
XX
yy
Y
X
S11
S1
S4
S3
S2
S7
S6
S5
S10
S
S4
W
ARNING
!
FIG. 25
FIG. 26
FIG. 27
FIG. 28
(Tool not included)
(Outil non joint)
(Herramienta no incluida)