Filter
Top Products
P-202H Plus v2 Support Notes
P-202H Plus v2 to WatchGuard Tunneling
This page guides us to setup a VPN connection between P-202H Plus v2 and
WatchGuard. As the figure shown below, the tunnel between PC 1 and PC 2
ensures the packets flow between them are secure. To setup this VPN tunnel,
the required settings for P-202H Plus v2 and WatchGuard are explained in the
following sections.
The IP addresses we use in this example are as shown below.
PC 1 P-202H Plus v2 WatchGuard PC 2
192.168.1.33
LAN: 192.168.1.1
WAN: 202.132.154.1
LAN: 192.168.2.1
WAN: 168.10.10.66
192.168.2.33
Note: The following configurations are supposed both two VPN gateways have
fixed IP addresses. If one of VPN gateways uses dynamic IP, we enter 0.0.0.0 as
the secure gateway IP address. In this case, the VPN connection can only be
initiated from dynamic side to fixed side to update its dynamic IP to the fixed side.
From this connection, the source IP is obtained and then update to the previous
0.0.0.0 field. However, if both gateways use dynamic IP addresses, it is no way
to establish VPN connection at all.
1. Setup P-202H Plus v2
1. Login P-202H Plus v2 by giving the LAN IP address of P-202H Plus v2 in
URL field. Default LAN IP is 192.168.1.1, default password to login web
configurator is 1234.
2. Click Advanced, and click VPN tab on the left.
3. On the SUMMARY menu, Select a policy to edit by clicking Edit.
All contents copyright © 2006 ZyXEL Communications Corporation.
186
4. On the CONFIGURE-IKE menu, check Active check box and give a name
to this policy.