Filter
Top Products
P-202H Plus v2 Support Notes
Key Settings:
o Select the 'Active' field to 'Yes'
o Select the 'Call Direction' to 'Incoming'
o Enter the correct node account for the dial-in router in 'Rem Login'
and 'Rem Password' fields
o Enter the IP address of the remote router in 'Rem IP Addr' field.
After you have finished the above settings, you are ready to make a test for this
connection from Menu 24.4.5- 'Manual Call' by entering the node number.
Menu 24.4 - System Maintenance - Diagnostic
ISDN System
1. Hang Up B1 Call 21. Reboot System
2. Hang Up B2 Call 22. Command Mode
3. Reset ISDN
4. ISDN Connection Test
5. Manual Call
TCP/IP
11. Internet Setup Test
12. Ping Host
Enter Menu Selection Number:
Manual Call Remote Node= N/A
Host IP Address= N/A
Configuring for Cisco Mutual Authentication
• Introduction
All contents copyright © 2006 ZyXEL Communications Corporation.
51
This configuration note explains what other settings you need to pay attention to
when configuring the P-202H Plus v2 talk to a Cisco router. Due to Cisco's
authentication scheme, you need to configure some additional fields in P-202H
Plus v2 when talking to a Cisco device. There are two things you must pay
attention to. The first is Cisco's mutual authentication scheme, and the second is
their interpretation of CHAP.