Filter
Top Products
P-202H Plus v2 Support Notes
Unconditional)
*22*forward-number# Active CFNR (Call Forwarding No Reply
#20# Deactive CFB
#21# Deactive CFU
#22# Deactive CFNR
12. How do I suspend/resume a phone call (terminal portability)?
The Terminal Portability service allows you to suspend a phone call temporarily.
You can then resume this call later, at another location if you so wish.
To suspend an active phone call:
• Press the flash key twice.
• Dial *3n*#, where n is any number from 1 to 9.
To resume your phone call:
• Reconnect at a (n) (ISDN) telephone that is linked to the same S/T
interface (Network Terminator-1, NT1) where you suspended the call.
• Pick up the handset and press the Flash key
• Dial #3n#, where n is any number from 1 to 9, but should be identical to
that used above.
13. What is reminder ring?
The P-202H Plus v2 sends a single short ring to your telephone every time a call
has been forwarded(US switches only).
14. Why doesn't my answering machine on POTS port stop recording?
Most answering machines stop recording when a busy tone is detected. But
some may not. Some answering machine only recongnize that a calling party has
hung up after a period of silence. In this case, if such an answering machine is
attched to the POTS port of P-202H Plus v2 you need to configure the 'Hangup
Silence Time(sec)=' in SMT menu 2.1 to determine the silence time period. By
doing so, once P-202H Plus v2 receives busy tones from the switch it sends the
silence tone to the answering machine on POTS meanwhile.
15. What are CLIP and CLIR in Advanced Setup of Menu 2 (European
firmware)?
CLIP or CLIR refers to CLID Presented or Restricted. The P-202H Plus v2 can
set the CLIP/CLIR bit at SETUP message to request the Switch, to include the
All contents copyright © 2006 ZyXEL Communications Corporation.
15