Filter
Top Products
P-202H Plus v2 Support Notes
5. Using FTP to Upload Firmware and Configuration Files
In addition to upload the firmware and configuration file via the console port and
TFTP client, you can also upload the firmware and configuration files to the P-
202H Plus v2 202 using FTP.
To use this feature, your workstation must have a FTP client software. There are
two examples as shown below.
1. Using FTP command in terminal
Step 1
Use FTP client from your workstation to connect to the P-202H Plus v2 by
entering the IP address of the P-202H Plus v2.
Step
2
Press 'Enter' key to ignore the username, because the P-202H Plus v2
does not check the username.
Step 3
Enter the SMT password as the FTP login password, the default is '1234'.
Step 4
Enter command 'bin' to set the transfer type to binary.
Step 5
Use 'put' command to transfer the file to the P-202H Plus v2.
Note: The remote file name for the firmware is 'ras' and for the configuration file
is 'rom-0' (rom-zero, not capital o).
Example:
C:\temp>ftp 202.132.155.97
Connected to 202.132.155.97.
220 FTP version 1.0 ready at Thu Jan 1 00:02:09 1970
User (202.132.155.97:(none)): <Enter>
331 Enter PASS command
Password:****
230 Logged in
ftp> bin
200 Type I OK
ftp> put p202e.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 924512 bytes sent in 4.83Seconds 191.41Kbytes/sec.
ftp>
Here, the 'p202e.bin' is the local file and 'ras' is the remote file that will be saved
in the P-202H Plus v2.
All contents copyright © 2006 ZyXEL Communications Corporation.
385