Filter
Top Products
P-202H Plus v2 Support Notes
The IP addresses we use in this example are as shown below.
PC 1 P-202H Plus v2 PC2
<Dynamic IP>
LAN: 192.168.1.1
WAN: <Dynamic IP>
192.168.1.33
1. Setup P-202H Plus v2
1. Configure P-202H Plus v2 to use DDNS for WAN IP address update. You
can refer to Using DDNS for how to configure it. We presume that you
have got a dynamic domain name, P-202H Plus v2.ddns.org, and update
your current WAN IP successfully.
2. Using a web browser, login P-202H Plus v2 by giving the LAN IP address
of P-202H Plus v2 in URL field. Default LAN IP is 192.168.1.1, default
password to login web configurator is 1234.
3. Go to Advanced -> VPN
4. Check Active box to enable this rule. Check Keep alive to make your
VPN connection stay permanent.
5. Select Negotiation Mode to Main..
6. Local IP, Address Type is Subnet, Address Start is 192.168.1.0,
End/Subnet Mask is 255.255.255.0.
7. Remote IP, leave this field as blank.
8. My IP Addr, leave this field as 0.0.0.0.
9. Secure Gateway IP Addr is Sentinel's IP, since Sentinel is using dynamic
IP address, fill this field as 0.0.0.0.
10. Select Encapsulation Mode to Tunnel.
11. Check the ESP check box. (AH can not be used in SUA/NAT case)
12. Select Encryption Algorithm to DES and Authentication Algorithm to
MD5..
13. Enter the key string 12345678 in the Preshared Key text box, and click
Apply.
14. Press Advanced button to set IKE phase 1 and phase 2 parameters.
All contents copyright © 2006 ZyXEL Communications Corporation.
321