Filter
Top Products
®
USER’S GUIDE
Battery Management System
105
When Boot mode is set to DHCP & BOOTP, two options are available:
• After IP Assignment in the control console (or Remain in DHCP &
BOOTP mode after accepting TCP/IP settings in the Web interface):
By default, this option switches Boot mode to the selection based on
the server that provided the TCP/IP settings (DHCP Only or BOOTP
Only).
• DHCP Cookie Is in the control console (or Require vendor specific
cookie to accept DHCP Address in the Web interface): By default,
this option requires that the DHCP responses include the APC cookie
in order to be valid.
When Boot mode is set to DHCP Only, two options are available:
• DHCP Cookie Is in the control console (or Require vendor specific
cookie to accept DHCP Address in the Web interface): By default,
this option requires that the DHCP responses include the APC cookie
in order to be valid.
• Retry Then Stop in the control console (Maximum # of Retries in the
Web interface), This option sets the number of times the Management
Card will repeat the DHCP request if it does not receive a valid
response. The default setting (0 in the Web interface, None in the
control console), requires that the Management Card continuously
send out DHCP requests until a valid DHCP response is received.
For more information about the APC cookie, see DHCP
response options.