APC Battery Management System Battery Charger User Manual


 
®
USER’S GUIDE
Battery Management System
49
Syslog
By default, the Battery Management System can send messages to up to
four Syslog servers whenever Battery Management System or the
embedded management card events occur. The Syslog servers, which
must be specifically identified by their IP addresses or domain names,
record the events in a log that provides a centralized record of events that
occur at network devices.
Syslog (and the event log) will also record discharge events including:
Discharge time and date
Discharge ambient and pilot battery temperature
Discharge measured current
Amp-hours removed from battery during discharge
Syslog settings. Leave the Syslog settings, except the Server IP settings,
set to their defaults unless otherwise specified by the Syslog network or
system administrator.
This user’s guide does not describe Syslog or its
configuration values in detail. For more information about
Syslog, see RFC3164, at www.ietf.org/rfc/rfc3164.
Setting Definition
General Settings
Syslog Enables (by default) or disables the Syslog feature.
Facility Selects the facility code assigned to the Battery Management System’s
Syslog messages (User, by default).
N
OTE: Although several daemon-specific and process-specific selections
are available, along with eight generic selections, User is the selection that
best defines the Syslog messages sent by the Battery Management
System.