®
USER’S GUIDE
Battery Management System
153
APC Device IP Configuration Wizard
Purpose and Requirements
Purpose: configure basic TCP/IP settings
You can use the APC Device IP Configuration Wizard to configure the basic
TCP/IP settings (IP address, subnet mask, and default gateway) of the
following:
• Network Management Cards
• Devices that contain embedded Network Management Cards
Using the Wizard, you can configure the basic TCP/IP settings of installed
or embedded Network Management Cards in either of the following ways:
• Automatically discover and configure unconfigured Network
Management Cards remotely over your TCP/IP network.
• Configure or reconfigure a Network Management Card through a direct
connection from the serial port of your computer to the device that
contains the card.
System requirements
The Wizard runs on Windows NT, Windows 2000, Windows 2003, and
Windows XP Intel-based workstations.
The Wizard can discover and configure Network Management
Cards only if they are on the same network segment as the
computer that is running the Wizard.