Filter
Top Products
®
USER’S GUIDE
Battery Management System
156
Run the Wizard to perform the configuration. To discover and
configure, over the network, installed or embedded Network Management
Cards that are not configured:
1. From the Start menu, launch the Wizard. The Wizard automatically
detects the first Network Management Card that is not configured.
2. Select Remotely (over the network), and click Next >.
3. Enter the TCP/IP settings (System IP, Subnet Mask, and Default
Gateway) for the unconfigured Network Management Card identified
by the MAC address at the top of the screen. Then click Next >.
4. On the Transmit Current Settings Remotely screen, if you check-
mark Start a Web browser when finished, the default Web browser
connects to the device that contains the Network Management Card
after you transmit the card’s settings.
5. Click Finish to transmit the TCP/IP settings. If the IP address you
entered is in use on the network, the Wizard prompts you to enter an IP
address that is not in use. Enter a correct IP address, and click Finish.
6. The Wizard searches for another installed or embedded but
unconfigured Network Management Card. If it finds one, it displays the
screen with data entry boxes for the TCP/IP settings of that card.
– To skip configuring the card whose MAC address is currently
displayed, click Cancel.
– To configure the TCP/IP settings of the next card, repeat this
procedure beginning at step 3.