Filter
Top Products
52
Arranging Embroidery Designs
Transferring Embroidery Designs to
Machines
The procedures for transferring the created embroidery pattern to an embroidery machine differ depending on
your embroidery machine model. For details, refer to the Operation Manual provided with your embroidery
machine.
Transferring to a machine
by using an original card
Designs can be transferred to
an embroidery machine
equipped with a card slot.
c
For details on writing multiple embroidery
designs, refer to “Writing Multiple
Embroidery Files to an Original Card” on
page 72.
1. Insert an original card into the USB Card
Writer Module.
2. Click , then ,
then .
3. When the following message appears, click
OK.
Data transfer begins. The following
message appears while the data is being
transferred.
4. After the data has been transferred, the
following message appears, indicating that the
transfer is finished. Click OK.
a Note:
• Be sure that the hoop size of the design
does not exceed the hoop that will be used
on the embroidering machine.
• When writing to an original card that
already contains data, all data on the card
will be deleted. Before writing to a card,
save all necessary data to a hard disk or
other media, and check that no necessary
data remains on the card.
c
“From an embroidery card” on
page 50
XE8656-001.book Page 52 Thursday, June 30, 2011 2:56 PM