Filter
Top Products
11
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
How to Install, Upgrade, or Downgrade NME-NAM-120S
Closing a Session
This section describes how to close a session on the network module.
Note • Before you install your application software, opening a session brings up the bootloader. After you
install the software, opening a session brings up the application.
• You can conduct only one session at a time.
• In NAM 4.0, the CLI command exit automatically closes a session.
SUMMARY STEPS
Use the following steps to close a session:
From the NAM CLI, NAM login, NAM helper, or NAM bootloader prompts
1. Control-Shift-6 x
From the Router prompt
2. disconnect <or>
service-module integrated-service-engine slot/0 session clear
DETAILED STEPS
Command or Action Purpose
From the NAM CLI, NAM login, NAM helper, or NAM bootloader prompts
Step 1
Press Control-Shift-6 x.
Note This key sequence returns you to the router prompt.
Closes the service-module session and
returns to the router CLI.
Note The service-module session
stays up until you clear it in
the next step. While it remains
up, you can return to it from
the router CLI by pressing
Enter.
From the Router CLI
Step 2
disconnect
or
service-module integrated-service-engine slot/0 session clear
Example:
Router# service-module integrated-Service-Engine 1/0 session clear
[confirm]
[OK]
Router#
Disconnects the session connection or
clears the service module session for
the specified module.
When prompted to confirm this
command, press Enter.