Filter
Top Products
45
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
Configuring the NME-NAM-120S For Network Connectivity
DETAILED STEPS
Troubleshooting Tips
If you have trouble opening a NAM console session from the router, ensure that the NAM console line
is clear by entering the service-module analysis-module slot/0 session clear command in privileged
EXEC mode.
What to Do Next
Verify that the default root password of root is accepted by performing the steps described in the
“Closing a Session” section on page 11.
To change the NAM root password, see the “Changing the NAM Root Password” section on page 43.
Opening and Closing a Telnet or SSH Session to the NAM
This procedure opens and closes a Telnet or SSH session to the NAM. This procedure is not commonly
performed, because you would typically use the NAM Traffic Analyzer (web GUI) to monitor and
maintain the NAM. If, however, you cannot access the NAM Traffic Analyzer, then you might want to
use Telnet or SSH to troubleshoot from the NAM CLI.
If your NME-NAM-120S is not properly configured for Telnet or SSH access (see the following
Prerequisites, page 45 section), then you can open a Telnet session to the router in which the
NME-NAM-120S is installed, and then open a NAM console session from the router. See the “Opening
a Session” section on page 10.
Prerequisites
• Configure the NAM system IP address. Optionally, set the NAM system hostname. See the
“Configuring the NME-NAM-120S For Network Connectivity” section on page 34.
• Verify NAM network connectivity by performing one of the following ping tests:
–
From a host beyond the gateway, ping the NAM system IP address.
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
service-module integrated-service-engine slot/0
password-reset
(or for the NM-NAM)
analysis-module slot/0 password-reset
Example:
Router# service-module integrated-service-engine 1/0
password-reset
Reloads the software on the
NME-NAM-120S.