Filter
Top Products
46
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
Configuring the NME-NAM-120S For Network Connectivity
–
From the NAM CLI, ping the NAM system default gateway.
Telnet Prerequisites
• Enter the exsession on NAM CLI command. See Step 5 of the “Configuring the NME-NAM-120S
For Network Connectivity” section on page 34.
SSH Prerequisites
• Install the NAM software K9 cryptographic patch, which you can download from Cisco.com.
• Enter the exsession on ssh NAM CLI command. See Step 5 of the “Configuring the
NME-NAM-120S For Network Connectivity” section on page 34.
SUMMARY STEPS
1. telnet {ip-address | hostname}
or
ssh {ip-address | hostname}
2. At the login prompt, enter root.
3. At the password prompt, enter your password.
or
If you have not changed the password from the factory-set default, enter root as the root password.
4. Perform the tasks that you need to perform in the NAM CLI. When you want to end the Telnet or
SSH session to the NAM and return to the Cisco IOS CLI, complete Step 5 and Step 6.
5. exit
6. logout
DETAILED STEPS
Command or Action Purpose
Step 1
telnet {ip-address | hostname}
or
ssh {ip-address | hostname}
Example:
Router# telnet 10.20.30.40
Example:
Router# ssh 10.20.30.40
Logs in to a host that supports Telnet.
or
Starts an encrypted session with a remote networking
device.
• Use the NAM system IP address or NAM system
hostname.
Step 2
At the login prompt, enter root.
Example:
login: root
Accesses the root (read/write) level of NAM.