Filter
Top Products
14
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
How to Install, Upgrade, or Downgrade NME-NAM-120S
http://www.cisco.com/cgi-bin/tablebuild.pl/nme-nam
b. Locate the following file:
• nam-app.4.0.bin.gz
NME-NAM-120S Application Image Release 4.0 for Cisco Branch Routers
Note Most URL links are not usable during Early Field Trial.
c. Download the files to one of the following locations:
• FTP file server
• HTTP server
Step 2 Reset the system:
Router> enable
Router# service-module integrated-service-engine slot/0 reload
Step 3 Session into the NME-NAM-120S console.
ServiceEngine boot-loader> service-module integrated-service-engine slot/0 session
While the service module reboots, it displays the following prompt:
Enter *** to change boot configuration:
Step 4 Enter *** to go to the bootloader.
After you enter ***, you will be at the bootloader prompt. From this prompt, you can either boot the
NAM helper located at a TFTP server or boot the pre-installed helper image in the NAM flash.
–
To boot the NAM helper image from a TFTP server, do Steps 5, 6, and 7. Skip Step 8, then do
Steps 9, 10, and 11.
–
To boot the pre-installed helper image on the NAM compact flash, skip Steps 5, 6, and 7, then
do Steps 8 through 11.
Step 5 Configure the bootloader to load and launch the helper:
ServiceEngine bootloader> config
Prompts for the following appear in the order listed. For each, enter a value or accept the previously
stored input that appears inside square brackets by pressing Enter.
• NME-NAM-120S IP address and subnet mask
• TFTP file-server IP address
• Default gateway of NME-NAM-120S (normally the IP address for the ISR)
• Default helper image filename
• Ethernet interface: internal or external of NME-NAM-120S