Filter
Top Products
21
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
Configuring the NME-NAM-120S for Management
Configuring the NME-NAM-120S for Management
NME-NAM-120S has an internal Gigabit Ethernet interface and an external interface. You can use either
interface for NAM management traffic such as the NAM web GUI, telnet or ssh, but not both. You can
configure the NAM internal interface to use either IP unnumbered or a routable subnet.
See the following sections for information about how to configure the NME-NAM-120S internal
interfaces for management:
• Configuring the Internal Interface for Management—IP Unnumbered, page 21
• Configuring the Internal Interface for Management—Routable Subnet, page 25
• Configuring the External Interface for Management, page 28
Configuring the Internal Interface for Management—IP Unnumbered
This section describes how to configure the NME-NAM-120S internal interface for IP unnumbered.
Note The addresses used for the interface address (Step 4), the NAM-Address (Steps 6 and 9), and the
NAM-Default-Gateway-Address (Step 7) must all be in the same subnet.
SUMMARY STEPS
From the Router Prompt
1. enable
2. configure terminal
3. interface integrated-service-engine slot/0
Step 9
Select 4, and follow the prompt to enter a FTP URL
Main menu
1 - Download application image and write to HDD
2 - Download application image and reformat HDD
3 - Download bootloader and write to flash
4 - Download helper and write to Compact Flash
5 - Display software versions
6 - Reset application image CLI passwords to default
7 - Change file transfer method (currently ftp/http)
8 - Show upgrade log
9 - Send Ping
f - Format the Flash
r - Exit and reset Services Engine
h - Exit and shutdown Services Engine
Selection [123456789frh]: 4
Download helper image from FTP server
and write to NAM flash.
Step 10
Select r and confirm to reboot the NAM
Reboot the NAM. By default the NAM will
boot to the NAM application image.
Step 11
Follow the steps described in Closing a Session, page 11 to
close the NAM console session.
Close the NAM console session.
Command or Action Purpose