Filter
Top Products
48
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
Configuring the NME-NAM-120S For Network Connectivity
Opening and Closing an SSH Session to the NAM Using the NAM System Hostname
host [/home/user] ssh -l root nmnam2
root@nmnam2’s password: <password>
Terminal type: vt100
Cisco Network Analysis Module (NME-NAM-120S) Console, 4.0
Copyright (c) 1999-2008 by Cisco Systems, Inc.
WARNING! Default password has not been changed!
root@nmnam2.company.com#
root@nmnam2.company.com# logout
Connection to nmnam2 closed.
host [/home/user]
Managing the NME-NAM-120S
This section contains the following information:
• Shutting Down and Starting Up NME-NAM-120S, page 48
• Verifying System Status, page 50
• Configuring Logging Options and Generating Diagnostics, page 51
Note • The tables in these sections show only common router and network module commands.
–
To view a complete list of available commands, type ? at the prompt
(Example:
Router(config-if)# ?).
–
To view a complete list of command keyword options, type ? at the end of the command
(Example:
Router# service-module integrated-service-engine ?).
• The tables group commands by the configuration mode in which they are available. If the same
command is available in more than one mode, it might act differently in each mode.
Shutting Down and Starting Up NME-NAM-120S
To shut down or start up the network module or the NME-NAM-120S application that runs on the
module, use commands as needed from the following list of common router and network module
commands (Table 3).
Note • Some shutdown commands can potentially disrupt service. If command output for such a command
displays a confirmation prompt, confirm by pressing Enter or cancel by entering n and pressing
Enter. Alternatively, prevent the prompt from displaying by using the no-confirm keyword.
• Some commands shut the module or application down and then immediately restart it.