Filter
Top Products
13
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
How to Install, Upgrade, or Downgrade NME-NAM-120S
Upgrading the NME-NAM-120S Application Image (Full Image)
This section provides summary and detailed steps about how to upgrade, downgrade, or re-install the full
NME-NAM-120S application image.
SUMMARY STEPS
From the Router CLI
1. Download the required software.
2. service-module integrated-service-engine slot/0 reload
3. service-module integrated-service-engine slot/0 session
From the Service-Module Interface
While the service module reboots, it displays the following prompt:
Enter *** to change boot configuration:
4. Enter ***.
After you enter ***, the NAM should display the bootloader prompt. From this prompt, you can
either boot the NAM helper located at a TFTP server or boot the pre-installed helper image in the
NAM flash.
–
To boot the NAM helper image from a TFTP server, do Steps 5, 6, and 7. Skip Step 8, then do
Steps 9, 10, and 11.
–
To boot the pre-installed helper image on the NAM compact flash, skip Steps 5, 6, and 7, then
do Steps 8 through 11.
5. configure
(and follow the prompts)
6. show config
7. boot helper
8. boot compactflash
Note For NM-NAM, enter boot flash.
At this point, you should be at the helper image menu.
9. Select either option 1 or option 2, and follow the prompts.
10. Select r.
11. Close the session as described in Closing a Session, page 11.
DETAILED STEPS
Step 1 Download the NME-NAM-120S installation-package files (containing a kernel image, a helper image,
and the NME-NAM-120S application software files) as follows:
a. Go to the NAM page of the Cisco Software Center website at the following location: