Filter
Top Products
6
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
NAM Software
Hardware Interfaces
The host router and network module use several interfaces for internal and external communication (see
Figure 1). Each interface is configurable both from the router by using the Cisco IOS CLI and from the
module by using the module's CLI.
The NME-NAM-120S can monitor traffic on both the external and the internal interface at the same time.
However, only one can be used for management traffic.
Figure 1 Router and Network Module Interfaces
On This Hardware Interface... Configure These Settings... Using This Configuration Method
1 Router interface
(for example, Gig0/0)
Standard router settings Router’s Cisco IOS CLI
2 Router side interface to
NME-NAM-120S.
This is the integrated-service-engine
interface on the router.
Module’s IP address and default
gateway router
3 INTERNAL interface of the
NME-NAM-120S.
This is a Gigabit Ethernet (GE)
interface.
All other module and
NME-NAM-120S application
settings
Module’s NME-NAM-120S CLI,
GUI, telnet, SSH interface, or
SNMP
4 EXTERNAL interface of the
NME-NAM-120S. This is a Gigabit
Ethernet interface.
Support for data requests and
transfers from outside sources