Filter
Top Products
7
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
How to Install, Upgrade, or Downgrade NME-NAM-120S
How to Install, Upgrade, or Downgrade NME-NAM-120S
This section contains the following information:
• Setting Up Network Module Interfaces, page 7
• Closing a Session, page 11
• Upgrading or Reinstalling NAM Software, page 12
Note • If you lose power or connection during any of the following procedures, the system usually detects
the interruption and tries to recover. If it fails to do so, fully reinstall the system using the boothelper.
• You can configure the network module by means of either the CLI or the GUI. This document
presents CLI configuration instructions. For GUI configuration instructions, see the GUI’s online
help.
Setting Up Network Module Interfaces
Your first configuration task is to set up network module interfaces to the host router and to its external
links. This configuration enables you to access the module to install and configure NME-NAM-120S.
Note The first few steps open the host-router CLI and access the router’s interface to the module. The
subsequent steps configure the interface.
SUMMARY STEPS
From the Host-Router CLI
1. enable
2. configure terminal
3. interface integrated-service-engine <slot>/0
4. ip address router-side-ip-address subnet-mask
or
ip unnumbered type number
5. [Optional, but if done, do not do Step 6] service-module ip address module-side-ip-address
subnet-mask
6. [Optional, but if done, do not do Step 5] service-module external ip address external-ip-address
subnet-mask
7. [Optional] service-module ip default-gateway gateway-ip-address
8. end
9. copy running-config startup-config
10. show running-config