Filter
Top Products
20
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02
How to Install, Upgrade, or Downgrade NME-NAM-120S
DETAILED STEPS
Command or Action Purpose
Step 1
Download the NME-NAM-120S helper image from CCO and load it
to an FTP server.
Note The FTP server must be reachable
from NAM CLI.
Step 2
From the router exec prompt, apply the IOS command:
service-module integrated-service-engine slot/0 reload
Example:
Router# service-module integrated-Service-Engine 1/0 reload
Use reset only to recover from shutdown or failed state
Warning: May lose data on the hard disc!
Do you want to reset?[confirm]
Trying to reset Service Module Integrated-Service-Engine1/0.
Reboot the NAM.
Step 3
service-module integrated-Service-Engine slot/0 session
Example:
Router# service-module integrated-Service-Engine 1/0 session
Trying 172.20.98.151, 2066 ... Open
Open a connection to the NAM console.
Note Pay attention to the messages that
scroll up the screen. When
prompted to enter ***, do so
Step 4
Enter ***
Note If you want to boot the pre-installed helper image, skip Steps 5,
6 and 7.
Note If you do Steps 5, 6, and 7, skip Step 8.
Note Step 5, 6, and 7 are useful in case the pre-installed helper image
on the NAM flash has been corrupted. These steps reinstall the
helper image.
Break to the NAM bootloader prompt.
Step 5
configure
Configure the bootloader to load and
launch the helper.
Note Follow the prompts to enter NME
address, subnet mask, TFTP server
address, NAM default gateway
address, helper image filename.
Press Enter to accept the
previously store input that appears
inside the square brackets.
Step 6
show config
Verify the bootloader configuration.
Step 7
boot helper
Boot the NAM helper image that is located
on the TFTP server.
Step 8
boot compactflash
Note Skip this step if you performed Steps 5, 6, and 7.
Boot the helper image located on the NAM
flash. For NM-NAM, enter boot flash.
Note NAM is shipped with a helper
image on its flash memory.