Filter
Top Products
ASSEMBLING TABLE EXTENSIONS
See Figure 10.
• Locatethe table extensionsand the smal_hardware
bag withthe following:
8 hex bolts(5/16-18 x 1-1/4 in.)
8 hex nuts (5/16-18)
16 fiatwashers (5/16 in.)
,_ WARNING: The table extensions notonly
providea supportfor large or wide pieces of
material, but help protectyou. Serious injury
can result from workpiece bindingor kickback
due to twisted rails or a misaligned rip fence.
• With the saw upsidedown, align table extensionsto
the sawtable. Put a flat washer on each bolt,and
attachthe extensionsto the table by insertingbolts
throughholes from the directionofthe table.
• Slipthe remaining flat w_shers and hex nuts on the
bolts. Lightly tighten with a 12 mm wrench.
• Get helpto standsaw assemblyupdghtusingthe
centersaw table. Do notgrasp saw by extensions.
_i, WARNING: Do not lift the saw table without
help. Hold it closeto your body. Keep your
kneesbent and liftwithyourlegs, not your back.
Ignoringthese precautionscan resultin back
injury.
ALIGNING TABLE EXTENSIONS
See Figure 11.
A good alignmentallowsthe railsto slideon easily.
• Standat the frontofthe saw and lineup the front
edgesof the table and extensions.
• ifadjustmentsare needed, puta blockof wood
wherethe extensionmeetsthe table, and tap the
blockof woodwith a hammer.Check and repeat
untilthe frontedges are even.
• Lifteach extensionslightlyuntilit is higherthan
table (if necessary,placea blockbelowand tap
upward).Center the blockofwoodoverthe edges
and tapit. Recheckthe front alignment.Ifeven,
tightenthe screwswith a 12 mm wrer,_h.
BLOCK TABLE
OFWOOD EXTENSION
TABLE
EXTENSION
SAW
TABLE
BLOCK TAP TABLE
OFWOOD HERE EXTENSION
HEX
HEAD BOLT
FLA;
WASHER
HE](NUT
Fig. 10
Fig. 11
eRRFTSMRI_ TABLESAW3152.28310 20