Filter
Top Products
REMOVING / REPLACING THE THROAT
PLATE
See Figure41.
,_ WARNING: Make sure the switch is off,the
switchkey is removed, and your saw is
unplugged.Failureto do so could resultin
accidentalstarting, resultingin sadous personal
injury.
• To remove the throatplate,firstloosenthe screwin
the throatplatewith a phillipsscrewdriverand lift
the frontend. Pull itouttoward the frontofthe saw.
• To re-installthethroat plate, place It inthe opening.
Push ittowardthe rear of saw base to engage the
spdngclip.
Note: The keyslotinthe throat plate willdrop over the
screw.
• Check thatthe throatplate iseven withthe table
top. Ifnot, adjustthe fourset screwswith a 2
mm hex key. See the procedureinthe Assam-
b/ysection.
• Socure_ytightenthroat plate screw. Do not allow
the throatplateto bow up above thetable surface.
THROATPLATE
KEYSLOT
SPRINGCLIP
TABLE
Fig. 41
CRIIFI3MAN" TABLESAW31tL_8310 32