Filter
Top Products
PROBLEM CAUSE SOLUTION
Sawdoesnotstart. 1. Motorcordorwallcordisnot 1. Pluginmotorcordorwallcord.
pluggedin.
2. Circuitfuseisblown.
3. Cimuitbreakeristripped.
4. Cordorswitchisdamaged.
Sawisnoisywhenrunning.
Motorissloworweak.
Motoroverheats.
Motorstalls,blowsfuses,ortrips
circuitbreakers.
1. Motor needs attention.
1. Voltage from sourceis low.
2. Windingsare burnedout or
open.
3. Start switchis defective.
4. Circuit is overloaded with
appliances, lights, or other
motorS.
1. Motor isoverloaded.
2. Du$$blade.
3. Sawdust insidesaw is blocking
air flow.
1. Starter switchisdefective.
2. Voltage from sourceis low.
3. Dull blade.
4. Fuses or circuitbreakersare
wrong size or defective.
5, Feeding workplacetoo rapidly,
2. Replace circuitfuse.
3. Reset circuitbreaker.
4. Have the cord or switchre-
placed at your nearest Sears
Service Center.
1. Have the motorcheckedat
your nearest Sears Service
Center.
1. Requesta voltagecheckfrom
the powercompany.
2, Have the motorcheckedat
yournearest Sears Service
Center.
3, Have the switch replaced.
4. Do not use other appliances or
motorson the same circuit
when usingthe saw.
1. Request a voltagecheckfrom
the power company.
2. Replace the blade.
3. Clean out the saw base.
1. Have the switch replaced.
2. Request a voltage checkfrom
the powercompany.
3. Replace the blade.
4. Replace fuses or circuit
breakers.
5. Feed work,piece intoblade
slower.
CRIIFTSNRN"TABLESAW315.228310 42