Filter
Top Products
Jog Mode
Circulation T
hrough Gun Manifold
NOTICE
Do not circula
te fluid containing a blowing agent
without cons
ulting with your material supplier
regarding flu
id temperature limits.
Circulating
fluid through the gun manifold allows
rapid prehe
ating of the hose.
1. Install gun fluid manifold (P) on accessory
circulation kit (CK). Connect high pressure
circulation lines (R) to circulation manifold.
P
CK
R
The Fusion AP gun manifold is shown.
CK Gun
Manual
24636
2
Fusio
nAP
30981
8
256566
Fusion CS
313058
2. Route circulation lines back to respective
component A or B supply drum. Use
hoses rated at the maximum working
pressure of this equipment. See
Technical Specifications, page 102.
3. Follow procedures from Startup, page 55.
4. Turn main power switch on
.
5. Set temperature targets. See Targets, page 50.
6. Press
to circulate fluid in jog mode until
A and B temperatures reach targets. See
Jog Mode, page 60 for more information about
jog mode.
Jog Mode
Jogmodehastwopurposes:
• It can speed fluid heating during circulation.
• It can ease system flushing and priming.
1. Turn main power switch on
.
2. Press c
irculate
to enter jog mode.
3. Press up or down
to change jog speed
(J1 through J20).
Note
Jog speeds correlate to 3-30% of motor
power, but will not operate over 700 psi
(4.9 MPa, 49 bar) for either A or B.
4. Press
to start motor.
5. To s
top the motor and exit jog mode press
or .
60 3A1705J