Filter
Top Products
-16-
G0675 10" Jointer/Planer Combo Machine
Dust Collection
To connect a dust collection hose:
1. Fit the 4" dust hose over the dust port when
it is correctly positioned for jointer operation
(Figure 14) or planer operation (Figure 15),
and secure in place with a hose clamp.
DO NOT operate the Model G0675 with-
out an adequate dust collection system.
This machine creates substantial amounts
of wood dust while operating. Failure to use
a dust collection system can result in long-
term respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Figure 14. Dust hose attached to dust port set-
up for jointer operations.
Refer to the instructions on Page 22 (Planer
Operations Setup) for setting up the dust
chute for planer operations.
2. Tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper per-
formance.
Figure 15. Dust hose attached to dust port setup
for planer operations.