Filter
Top Products
-32-
G0675 10" Jointer/Planer Combo Machine
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
For optimum performance from your machine, fol-
low this maintenance schedule and refer to any
specific instructions given in this section.
First 3–5 Hours of Operation
• Re-tension belts.
• Lubricate elevation lead screws (Page 35).
Daily Check:
• Clean unpainted cast iron parts of jointer and
planer tables.
• Clean cutterhead.
Every 20 Hours of Operation
• Lubricate elevation lead screws (Page 35).
Every 40 Hours of Operation
• Check and re-tension belts (on this page).
• Lubricate cogwheels (Page 35).
Monthly Check:
• Lubricate feed roller chain and feed roller
sprockets (Page 35).
• Lubricate fence (Page 34).
• Lubricate outfeed table lock arm and pivot
points (Page 36).
• Clean/vacuum dust inside planer cabinet.
• Lubricate blade guard arm (Page 35).
Semi-Anually
• Lubricate table height chain and planer
handwheel linkage (Page 36).
Annually
• Lubricate table height chain and planer
handwheel (Page 36).
Schedule
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth—this
ensures moisture from wood dust does not remain
on bare metal surfaces. Treat all unpainted cast
iron and steel with a non-staining lubricant after
cleaning. We recommend products like SLIPIT
®
,
G96
®
Gun Treatment, or Boeshield
®
T-9 (see
Page 31 for more details).
Cleaning
Belts
V-belt and flat belt removal and replacement
involves removing the belts, rolling them off of
the pulleys, replacing them with new belts, then
re-tensioning them.
Always replace the belts simultaneously, or belt
tension may not be even among the belts and
may cause premature belt failure.
After the first three hours of operation, re-tension
the belts, as they will stretch and seat during this
time. Then check and re-tension if necessary
after 40 operating hours.
Tools Needed Qty
Wrenches 10 & 13mm ..................................1 Ea
Hex Wrenches 5 & 6mm ..............................1 Ea
Replacing Flat Drive Belt
1. DISCONNECT THE JOINTER/PLANER
FROM THE POWER SOURCE!
2. Raise the planer table to about the 6" mark.
Note: This maintenance schedule is based on
average usage. Adjust the maintenance schedule
to match your usage to keep your jointer/planer
running smoothly and to protect your investment.