Filter
Top Products
G0675 10" Jointer/Planer Combo Machine
-41-
—If the straightedge sits flat against both
the infeed and outfeed table, then the
tables are parallel. Continue to Inspecting
Knives on Page 42.
—If the straightedge does not sit flat against
both the infeed and outfeed table in
any of the positions, then continue to
the Adjusting Infeed Table Parallelism
instructions.
Adjusting Infeed Table Parallelism
1. Perform the "Checking/Adjusting Table
Parallelism" procedure on Page 39, including
making any necessary adjustments so the
cutterhead and outfeed table are parallel.
2. Place the straightedge halfway across the
infeed table and halfway over the outfeed
table, and adjust the infeed table even with
the outfeed table, as shown in Figure 61.
3. Place the straightedge in one of the positions
shown in Figure 62.
—If the front of the infeed table is higher or
lower than the outfeed table, or if the rear
of the infeed table is higher or lower than
the outfeed table, continue to Step 4.
—If the straightedge sits flat against both
the infeed and outfeed table, then the
tables are parallel. Continue to Inspecting
Knives on Page 42.
Checking Infeed Table Parallelism
1. Follow all the steps for checking the outfeed
table parallelism to first make sure that the
outfeed table is parallel with the cutterhead.
2. Place the straightedge halfway across the
infeed table and halfway over the outfeed
table, and adjust the infeed table even with
the outfeed table, as shown in Figure 61.
Straightedge
Outfeed Table Infeed Table
Figure 61. Infeed and outfeed tables set evenly.
3. Place the straightedge in the positions shown
in Figure 62. In each position, the straight-
edge should sit flat against both the outfeed
table and the infeed table—you should not
see any gaps between the bottom of the
straightedge and the infeed table.
—If a knife touches the straightedge, turn the
cutterhead so the knives do not interfere.
Black Lines Represent
Straightedge Positions
from Overhead View
Figure 62. Straightedge positions for checking
infeed/outfeed table parallelism.