Filter
Top Products
-42-
G0675 10" Jointer/Planer Combo Machine
5. While an assistant holds the straightedge
over both tables, lift or lower the infeed table,
then tighten the hex bolts and nuts as needed
so there is little to no visible gap between the
bottom of the straightedge and the top of the
infeed table.
6. Continue adjusting the infeed table until it
is parallel with the outfeed table in each of
the positions shown in Figure 62. Some trial
and error and a good deal of patience will
be needed to successfully accomplish this
adjustment.
Tip: Tighten the front and rear bolts finger
tight and tap the table up or down. This will
help dial in the adjustment.
7. Once the infeed and outfeed tables are par-
allel with each other, proceed to Inspecting
Knives.
Figure 64. Locations of the infeed table
adjustment bolts.
Inspecting Knives
Tools Needed: Qty
Knife Setting Gauge .......................................... 1
Straightedge ...................................................... 1
The height of the knives can be inspected with the
included knife setting gauge.
Inspecting the height of the knives ensures that
they are set evenly with the outfeed table at their
highest point in the cutterhead rotation.
To inspect the knives with the knife setting
gauge:
1. DISCONNECT THE JOINTER/PLANER
FROM THE POWER SOURCE!
2. Perform Steps 2–7 in Setting Outfeed Table
Height on Page 17.
— If the top of the knife just touches the bottom
of the gauge when it is at the highest point
of rotation on both sides of the cutterhead,
then that knife is set correctly. (Repeat this
inspection with the other knife.)
— If the top of the knife does not touch the
bottom of the gauge as described, then
reset that knife. Continue to Adjusting/
Replacing Knives on Page 43 (Repeat
this inspection with the other knife before
resetting.)
3. REPLACE the front access panel and the
blade guard assembly!
4. Loosen the eight hex bolts and flange nuts
on both sides of the infeed table, as shown in
Figures 63 and 64.
Figure 63. Location of infeed table adjustment
bolts, front view.