Filter
Top Products
-34-
G0675 10" Jointer/Planer Combo Machine
4. Remove the flat belt and V-belt, install a new
flat belt and V-belt in the same manner that
you removed them.
5. Push the wheel bracket (see Figure 48)
down and tighten the four cap screws, then
push the infeed belt wheel down and tighten
the cap screw loosened in Step 3.
6. Check the tension of each belt.
— If there is approximately
1
⁄2" deflection
when the flat belt or V-belt is pushed with
moderate pressure, the belts are correctly
tensioned.
— If there is more than
1
⁄2" deflection when the
flat belt or V-belt is pushed with moderate
pressure, repeat Steps 3–5, then check
the tension again.
7. Re-install the front and rear access panels
with the cap screws you removed earlier.
Figure 48. Cap screw locations.
Infeed
Belt
Wheel
Wheel Bracket
3. Loosen the four cap screws on the wheel
bracket, and one cap screw on the infeed belt
wheel (see Figure 48), then raise the infeed
belt wheel.
Lubrication
An essential step for lubrication is cleaning the
components before lubricating them.
This idea is critical because dust and chips build
up on lubricated components and make the
components hard to move. Simply adding more
grease to the components with built-up grime on
them will not yield smooth moving components.
Clean the components in this section with an oil/
grease soluble cleaner, such as mineral spirits.
The following are the main components that need
to be lubricated:
• Fence (on this page)
• Blade Guard Arm (Page 35)
• Leadscrews (Page 35)
• Feed Roller Chain, Sprocket and Cogwheels
(Page 35)
• Outfeed Table (Page 36)
• Table Height Chain (Page 36)
• Planer Table Handwheel (Page 36)
Schedules are based on average use. Adjust
lubrication according to your level of use.
Fence
Clean away any built up grime and debris with
a rag and mineral spirits, then place 1-2 drops
of light machine oil on the pivot points shown in
Figure 49 once a month. Move the fence through
its full range of motion to distribute the oil.
Figure 49. Fence lubrication locations.
V-belt
Flat Belt