Filter
Top Products
-22-
G0675 10" Jointer/Planer Combo Machine
Basic Planer
Controls
This section covers the controls used during rou-
tine planer operations.
See Page 20 for a description of the ON/OFF
switch.
Table Height Handwheel: To raise or lower the
planer table, rotate the table height handwheel
(Figure 25).
Table Height Scale: Read the depth-of-cut from
the inch scale.
Figure 25. Planer table control locations.
Table Height
Handwheel
Table Height
Scale
Jointer-Planer
Conversion
5. Remove the dust hose from the jointer dust
port, then remove the dust port.
6. Use the table height handwheel to lower the
planer table to approximately the 6" mark.
Serious personal injury could occur if you
place your fingers between the table and
base or between pivot points. Your hands
could be pinched or crushed!
The Model G0675 is ready for jointer operations
after it is setup. To use the machine as a planer,
you must perform a conversion.
Planer Operation Setup
1. DISCONNECT THE JOINTER/PLANER
FROM THE POWER SOURCE!
2. Loosen the fence lock lever, then remove the
fence.
3. Engage the blade guard lock knob and blade
guard arm lock lever (see Figure 24 on Page
21).
4. Disengage the outfeed table lock lever, and
raise the table up all the way so the pin seats
into the groove on the lock arm (Figure 26).
Figure 26. Outfeed table lock arm.