Filter
Top Products
-36-
G0675 10" Jointer/Planer Combo Machine
After lubricating the chain and handwheel mecha-
nism, make sure the outfeed table is locked, then
reverse the prior steps to reassemble the jointer/
planer.
Figure 56. Machine turned over for access to
table height chain.
To access the table height chain and planer table
handwheel linkage, remove the fence, front and
rear access panels, blade guard arm assembly,
and rear fence rail. With the help of an assis-
tant, lift the machine off the base, then turn the
machine over and place it upside down on blocks,
carpet, or cardboard (see Figure 56).
Figure 55. Table height chain and handwheel
linkage.
Table Height
Chain
Table Height Chain & Planer
Handwheel
Inspect the table height chain (see Figure 55)
every six months to a year. Clean away debris and
built-up grime on the chain with a rag and mineral
spirits, then apply a thin coat of multi-purpose
grease. Lubricate the planer table handwheel link-
age with light machine oil as needed.
Outfeed Table
Clean debris and grime from the outfeed table
lock arm and pivot points, then apply 1-2 drops
of light machine oil to the components shown in
Figure 54 once a month.
Figure 54. Outfeed table lubrication points.
Handwheel
Linkage