Filter
Top Products
G0675 10" Jointer/Planer Combo Machine
-19-
For your convenience, the adjustments listed
below have been performed at the factory and
no further setup is required to operate your
machine.
However, because of the many variables involved
with shipping and storage, some of these adjust-
ments may need to be repeated to ensure opti-
mum cutting results. Keep this in mind as you
start to use your new jointer/planer.
Step-by-step instructions for these adjust-
ments can be found in SECTION 7: SERVICE
ADJUSTMENTS.
Factory adjustments that should be verified:
1. Cutterhead Knife Height (Page 42)
2. Fence Stop Accuracy (Page 44)
3. Feed Roller Spring Tension (Page 46)
4. Jointer-Table Parallelism (Page 39)
Recommended
Adjustments
Belt Break-In
The final step in the setup process must be done
after approximately three hours of operation.
During this first three hours, the belts will stretch
and seat into the pulley grooves. After this, you
must re-tension the belts to avoid slippage and
burn out. Refer to Page 32 when you are ready to
perform this important adjustment.
Note: Pulleys and belts can get hot. This is a nor-
mal condition. Allow them to cool before making
adjustments.