Filter
Top Products
CHOPPER MODULE REMOVAL AND REPLACEMENT (CONTINUED)
REPLACEMENT
1. Mount the heat sink to the brackets on the ver-
tical baffle with the three 3/8” screws. Mount
the plastic strip with the top two screws.
2. Connect leads 23 and 25 at their in-line cou-
plers.
3. Using a 7/16” wrench, attach the heavy leads
and small leads as follows. Note placement of
leads and fasteners: screw, lock washer, flat
washer, small lead, heavy lead. Apply a thin
coating of electrical thermal joint compound
(Dow Corning) to the mating surfaces (but not
the threads). Tighten the fasteners to between
50-60 in-lbs.
4. Replace any cable ties cut at disassembly.
5. When procedures are complete, perform the
Case Cover Replacement procedure.
TROUBLESHOOTING & REPAIR
F-93 F-93
VANTAGE® 400
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC