Filter
Top Products
FLASHING VOLTAGE TEST (CONTINUED)
16. If battery voltage is present at leads #232 and
#232F, but not present at leads #200 The
engine protection / idle P.C.B. board is proba-
bly defective. Replace.
17. If battery voltage is present at lead #232, but
not present at leads #232F or #200 check the
engine protection wiring per the wiring dia-
gram.
18. If battery voltage is not present at lead #232,
check wiring per wiring diagram, and check
the run/stop switch. Also check the ground
PC board chassis ground wire, lead #5K and
the stud where it connects to the chassis.
19. Set the RUN/STOP switch to the “STOP”
position.
20. Re-connect lead #234 to the oil pressure
switch.
21. If testing is completed, perform the Case
Cover Replacement procedure.
TROUBLESHOOTING & REPAIR
F-49 F-49
VANTAGE® 400
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC