Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-23 F-23
CLASSIC II
ENGINE THROTTLE ADJUSTMENT TEST (continued)
FIGURE F.7 - STROBE MARK LOCATION
STROBE
MARK
TEST PROCEDURE
Strobe Tach Method
1. Turn the engine welder OFF.
2. Unlatch, lift and secure the right side door.
Note that there are latches at both ends of
the door.
3. With a white or red marking pencil, place a
mark on one of the blower paddles or on the
side of the flywheel. See Figure F.7 for loca-
tion.
4. Connect the strobe-tach according to the
manufacturer's instructions.
5. Start the engine and direct the strobe-tach
light on the blower paddle. Synchronize it to
the rotating mark.
With the machine at HIGH IDLE the tach
should read between 1780 and 1810 RPM.
With the machine at LOW IDLE the tach
should read between 1350 and 1400 RPM.