Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-36 F-36
CLASSIC II
ALTERNATOR ROTOR REMOVAL
AND REPLACEMENT (continued)
FIGURE F.15 – ROTOR REMOVAL
STATOR
FRAME
NUT
SLEEVE
COLLAR
"BENT"
WASHER
BRUSH
HOLDER
ASSEMBLY
See Figure F.15 for steps 22 - 24.
22. With the 7/16" wrench, remove the two bolts,
nuts and washers mounting the brush hold-
er assembly to the stator frame.
23. Bend the flat washer away from the rotor
locking nut.
24. With the 1-5/8" socket wrench, remove the
rotor locking nut, washer and sleeve collar.
Note: The sleeve collar will have to be
removed with a gear puller. Be careful not to
damage the rotor slip ring assembly.
Remove the rotor by pulling it free of the
generator shaft.