Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-60 F-60
LN-9 GMA Wire Feeder
PROCEDURE
1. Remove input power to the LN-9 GMA.
2.
Using the phillips head screwdriver remove the
screws holding the left side cover assembly.
3. Lift the cover.
4. Disconnect primary lead #532 from the power
PC board terminal.
5. Disconnect the primary lead #31 from the R1
(2 ohm) resistor. See Figure F.17. Upon
reassembly this lead will have to be soldered
onto the R1 resistor.
T1 TRANSFORMER REMOVAL AND REPLACEMENT (continued)
FIGURE F.17 – PRIMARY LEAD #31 AT R1 RESISTOR
LEAD 31
LEAD 532
R1 RESISTOR