Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-32 F-32
LN-9 GMA Wire Feeder
WIRE DRIVE MOTOR TEST (continued)
FIGURE F.6 – LEAD #539 AND #541 AT POWER PC BOARD TERMINAL STRIP
LEAD 539
LEAD 541
TEST PROCEDURE
1. Remove input power to the LN-9 GMA wire
feeder.
2. Remove any electrode wire or disengage
the drive rolls.
3. Using the phillips head screwdriver, remove
the screws from the left side cover assem-
bly.
4. Lift the left side cover assembly.
5. Locate leads #539 and #541 at the power
PC board terminal strip. See Figure F.6.