Filter
Top Products
Figure A.8 is a connection diagram for connecting the
LN-9 GMA to V300 power sources. The connection is
made with a K596 cable assembly, which has an
amphenol connection rather than a terminal strip con-
nection at the power source.
Depending on the power source and process you are
using, the jumpers on the LN-9 GMA voltage board
may have to be changed. As shipped, the LN-9 GMA is
connected for use with the DC-250 DC-400, CV-400,
CV-500-I and DC-600. For other power sources, refer
to the appropriate connection diagram.
NOTE: If you are using the Pulse Power 500, DC650
Pro, or V300 power source, the K442-1 Pulse Power
Filter Kit must be installed in the LN-9 GMA. See the
instructions included with the kit. If you are using the
Invertec V300, the K608-1 Adapter must also be
installed according to the connection diagram and
instructions provided in the Invertec Manual.
INSTALLATION
A-6 A-6
LN-9 GMA Wire Feeder
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC