Filter
Top Products
882.00207.00 Chapter 7: Appendix 100 of 102
RECORDING THE TARGETS VS. ACTUALS FOR EACH BATCH
The targets that are read are in lbs or kgs. When a batch is complete and dumped the blender will toggle
high the “print data now” bit. At this time you should then read the “actual displayed weights” values
and record them into a log or chart. If you are not getting the “print now” bit, then refer to the blender
manual to configure “print batch data”.
Note: If you chose to write the recipe to the raw recipe locations you run the risk of
inadvertently entering the incorrect recipe. This is not recommended because
it will bypass all the checks that the blender makes before letting you select
“accept new recipe”. Also if you chose to use the raw method then you must
add up the totals for your recipe and write that at the exact same time that you
write the other raw recipe values. You must also right the batch size and recipe
entry information or the blender might not make a batch.
Note: When the blender is not running the “target” values get set to “999999999” and
in the beginning of each batch all actual values get set to “999999999” until the
hopper feeds material into the new batch.