Filter
Top Products
882.00207.00 Chapter 4: Operation 46 of 102
Percentage Mode.) then a message is shown on the Recipe screen to alert the operator of the
problem. The “Accept New Recipe” button is only shown if the recipe is valid and different from
what is currently running on the blender.
Recipes can also be changed while the blender is running. The new accepted recipe is entered at the
beginning of the next batch. This allows the operator to modify the new recipe without affecting the
blender until they press the “Accept New Recipe” button.
Existing Recipes
The operator can load a previously stored recipe from the Recipe Book. The Recipe book also
allows the operators to save the current running recipe. This can be done by performing the
following steps:
1. Touch the Recipe Book icon located on the Recipe Screen.
2. Select a stored recipe by changing the number next to “Recipe #.”
3. Touch “Load” and then “Done.” This will take you back to the Recipe Screen.
4. Touch “Accept New Recipe” to accept the loaded recipe into the blender.
To save a running recipe to the Recipe Book:
1. Go to the Recipe Book by touching the Recipe Book icon located on the Recipe Page.
2. Select a stored recipe by changing the number next to “Recipe #.”
3. Touch “Save Running Recipe” and then “Done.”
4-2 Operation Procedures
The objective of this section is to familiarize the reader with the Slide Gate blender recipe menus,
run mode operation, run mode menus and displays. Upon the completion of this section, the reader
will be familiar with the recipes and run mode displays that are available on one blender, including
the recipe book and recipe storage facilities. Other items covered in this section are optional printer
functions and report generation capabilities of the Slide Gate/Auger blending system.
Topics covered in this section are:
• General Operation
• Recipe Menu
• Optional Printer Menu
All personnel operating the Slide Gate/Auger blending system should read this section of the manual
before operating the blending system.
Operator Displays
The Slide Gate/Auger blending system utilizes a standardized menu format. Each screen was
designed to be user-friendly and provide the operator with the necessary information to run the
blender.
Note: Press “Push to Start or Stop” button to start blender.