Filter
Top Products
882.00207.00 Chapter 3: Installation 42 of 102
4. The current settings for the hopper that you have chosen will now be shown on the screen.
5. Make the necessary adjustments to the “Stop/Continue if “Out of Material,” Alarm/No
Alarm on “Out of Material,” and “Out of Material Alarm Silence Delay” (0-60 seconds)
settings. Once the settings for these features have been set on the displayed feeder, select a
new feeder to configure as desired.
6. Press the “Done” key at the bottom to exit this screen.
Network Setup
The blender’s baud rate is the speed at which data is transferred to and from the blender’s
communication port. The blender IP is the address of this blender on a network. The Slide Gate
blender is factory set up at 192 baud, with an IP address of 01.
In order to change the values, enter the Setup menu, press the “Network Setup” button and change
the values accordingly. Baud rates available are 120, 240, 480, 960, 192. Blender ID’s can range
from 1 through 255.
Figure 31: Ethernet Setup Screen
Setting Date and Time
The Set Date & Time feature is located in the “Panel View Config” menu of the Setup Screen. This
feature allows the operator to set the Slide Gate/Auger Blender’s internal time clock and date. The
clock data must be entered in the traditional Hours, Minutes, and seconds. The date must be entered
in Years, Months, and Days. All values in this screen can be entered by pressing on the
corresponding button and choosing the correct number.
Figure 32: PanelView Configuration Screen
Go back to Setup
Directory
Enable or Disable
the Ethernet
Module
Configurator
Go back to Setup
Directory
Press to set
Date & Time