Filter
Top Products
882.00207.00 Chapter 3: Installation 37 of 102
This screen displays the software version of both the PLC and the Panel View. The Controller will
stay on this screen for about 10 seconds or you can touch the picture of the blender to quickly skip to
the Recipe Screen (Next Screen in sequence). The software versions are also available on the Panel
View Configuration Screen.
Figure 27: Display Main (Recipe) Screen
If not, the blender can be reconfigured for Quick Set, Percent, or Parts by entering the Setup menu
and pressing the Recipe Format key. Then select the mode following the key prompt on the screen.
To access the Setup Menu to change the Recipe Mode and other controller features, refer to the
following pages of this manual.
Controller Set-up
This section describes the proper setup of the Slide Gate blending system control parameters. These
parameters are operator changeable; however, these items should only require setup during the initial
installation. Only authorized personnel should change them. For security reasons, the menu that is
used to access these parameters is password protected.
Many of the variables and setup parameters have been preset at the factory and do not need to be
changed. However, this section of the manual will address all of the blender setup parameters that
were available at the time of printing. The purpose of this is to familiarize the reader with all the
setup parameters and their usage.
A complete listing of all default values is provided at the end of this manual.
Recipe Entry Mode
Mixer Status
Start/Stop
Blender
Immediately
Stop Blender
Accept New Recipe
Go To Recipe
Book
Go To Inventory
Screen
Feeder Type
Indicator
New Recipe
In
p
ut