Filter
Top Products
882.00207.00 Chapter 7: Appendix 88 of 102
Typical Advanced Weight Options Screen
Feed Algorithm Options Screen
This screen allows the user to configure how the blender metering algorithm works. The user can
adjust the Initial percentage of Target to Meter, the Allowed Underfeed value, the number of retries
before Double Gate Time, the allowed Weight/Sec Drop, and the Out of Material retry limit.
Typical Feed Algorithm Options Screen
Feed Calibration Options Screen
This screen allows you to perform the feeder calibrations for each feeder (in weight per second).
This is useful when the feed calibration is giving you an error message (most commonly caused by
overfilling the hopper during the calibration). Select a feeder and then follow instructions. An error
is shown if the current feeder calibration feed time was too short, the feed time was too long, or if
the hopper weight exceeded 110% of the set batch weight. In the case that the feeder exceeded
110% (maximum hopper weight) due to a high rate hopper then the “Batch % for Feeder Cal” setting
might be set too high. Consult the manufacturer if this problem arises. The current feeder
calibration values are also shown on this page. It is not necessary to perform feeder calibrations.
The blender will automatically learn these values during the batch.
Typical Feed Calibration Options Screen
Weight Filter
Weight/Sec.
Filte
r
Adjust the limit
for “Hopper Over
Max Wei
g
ht”
Adjust Settle
Go back to
Engineering Only
Director
y
Go back to
Engineering Only
Directory
Go back to
Engineering Only
Directory.