Fujitsu MHC2040AT Drill User Manual


 
Index
IN-2 C141-E050-02EN
Command, without data transfer 5-73
Command block register 5-8
Command code 5-14, 5-67
Command description 5-16
Command processing 4-9
Command protocol 5-69
Command register 5-12
Command that is object of caching operation
6-14
Command without data transfer 5-73
Compact 1-2
Compensating open loop gain 4-8
Configuration, circuit 4-4, 4-5
Configuration, data buffer 6-14
Configuration, device 2-1
Configuration, sector servo 4-16
Configuration, system 2-4
Connection, 1-drive 2-4
Connection, 2-drive 2-5
Connection, cable 3-7, 3-8
Connection, device 3-8
Connection to interface 1-2
Connector, device 3-7
Connector, power supply 3-9
Connector location 3-7
Content, self-calibration 4-7
Content of security password 5-59
Content of SECURITY SET PASSWORD
data 5-64
Control, actuator motor 4-19
Control, servo 4-14
Control, spindle motor 4-20
Control block register 5-13
Controller circuit 2-4, 4-4
Converter, A/D 4-17
Converter, D/A 4-17
CORR 5-12
Corruption, data 3-6
CSEL setting 3-11
Current attribute value 5-58
Current fluctuation 1-6
Current fluctuation when power is turned on
1-6
Current requirement 1-6
Cylinder High register 5-10
Cylinder Low register 5-10
D
DAC 4-17
D/A converter 4-17
Data, object of caching operation 6-15
Data area 4-18
Data assurance in event of power failure
1-9
Data buffer 1-3
Data buffer configuration 6-14
Data corruption 3-6
Data format version number 5-57
Data register 5-8
Data separator circuit 4-13
Data-surface servo format 4-18
Data that is object of caching operation
6-15
Data transfer, multiword DMA 5-79
Data transfer, PIO 5-76
Data transfer, single word DMA 5-78
Data transfer rate 4-13
Data transferring command 5-69, 5-71
Data transfer timing 5-77
DE 2-4
Decoder, 8/9 GCR 4-13
Default parameter 6-7
Defect management 6-11
Device configuration 2-1
Device connection 3-8
Device connector 3-7
Device Control register 5-13
Device/Head register 5-10
Device overview 1-1
Device response to reset 6-2
DF 5-12
Diagnostic code 5-9
Dimension 3-2
Disk 2-2, 4-2
Disk enclosure 2-4
Disk media 2-3
DMA data transfer command 5-74
DMA data transfer protocol 5-74
DRDY 5-11
Driver 4-17
Driver circuit 4-17
DRQ 5-12
DSC 5-12
E
Effect, blower 4-3
Environmental specification 1-7
ERR 5-12
Error, positioning 1-9
Error, unrecoverable read 1-9
Error correction by ECC 1-3
Error correction by retry 1-3