Filter
Top Products
Chapter 2 57
Troubleshooting
Identifying LCD-Indicated Conditions
WRN 80F6 EXT IO boot read error Cannot load IODC entry_io for boot
device.
WRN 80F7 EXT IO boot IO error Error detected during boot device I/O.
WRN 80F8 EXT IO invalid boot dev Invalid boot device class; bad IODC?
WRN 80FC EXT IO invalid boot dev Unexpected error; bad IODC?
INI 8800 IOCARD PCI BusWlk start Starting PCI bus and device discovery.
INI 88r1 IOCARD PCI Rope r walk Starting PCI bus and device discovery on
Rope r.
INI 8802 IOCARD PCI BusWalk done PCI bus and device discovery complete.
INI 8803 SYS BD PCI alloc done Done allocating address space for PCI
devices.
INI 8804 SYS BD PCI config done Done configuring PCI devices.
FLT 881r IO BD R2PCI
r
not found Rope-to-PCI bridge r not found.
WRN 882
r
IO BD R2PCI
r
not found Rope-to-PCI bridge r initialization failed.
FLT 883r IO BD Rope
r
config err Rope r configuration failed.
INI 884
r
EXT IO Rope
r
debug tggl Rope r debug register toggled.
FLT 884
r
EXT IO Rope
r
tgl fail Rope r debug register toggle failed.
INI 8850 SYS BD early rope0 init Initializing rope 0 for early RS-232
output.
FLT 8850 SYS BD rope0 init fail Couldn’t initialize rope 0.
INI 8860 SYS BD rope0 init done Rope 0 initialization complete.
INI 8870 IO BD early R2PCI init Initializing Rope-to-PCI bridge 0 for early
RS-232 output.
FLT 8870 IO BD R2PCI init fail Couldn’t initialize Rope-to-PCI bridge 0.
INI 8880 IO BD R2PCI init done Rope-to-PCI bridge 0 initialization
complete.
INI 8890 IO BD early Super init Initializing Super-I/O for early RS-232
output.
FLT 8890 IO BD Super init fail Couldn’t initialize Super-I/O.
INI 88A0 IO BD Super init done Super-I/O initialization complete.
WRN 8A03 EXT IO No graph console Cannot re-establish communications with
the graphics console.
Table 2-1. Chassis Codes for J6000 Workstations
Ostat Code FRU Message Description